Mitsubishi X30 Specifiche Scaricare il pdf (Pagina 7)

www.m16canz.com

Flash Start Setup

1. Register Flash Start in Tool Manager by clicking the Tool Register button.

2. Select the Application tab and fill in the Name and File Path fields.

3. Click the OK button. Flash Start will now be available from the TM Project Bar.

Monitor Program Installation

1. The Starter Kit board will normally be delivered without the monitor program installed. To install

the monitor program, set up the Starter Kit board by connecting the 9-pin serial cable to the SK

DB9 connector and to the PC RS-232 port.

2. Prior to connecting the DC power supply to the board (either 9V or 5V), make sure that the

CNVss jumper is fitted (located next to the 9V socket). This will allow the M16C MCU to startup in

“boot” mode where the CPU starts operating using the standard serial I/O control program in the

boot ROM area. This control program allows the Flash ROM to be programmed via the serial I/O

port.

1 2 3 4 5 6 7 8 9 10 11 12 13 14

Nessun commento

Mitsubishi X30 Specifiche Pagina 7